The NRGP Spare Battery¶

The Green-GO NRGP is a battery pack for use with the Green-GO WBPX or WBPXSP BeltpackX, and Green-GO BC6 battery charger.

Handeling bateries¶

• Care should always be taken when handling batteries. Using excessive force to remove batteries from a device can cause damage, so be careful
• Prevent any other large physical forces on the batteries like dropping or pressure
• Any swollen, dented or otherwise damaged batteries should be disposed of according to local legislation
• Only use Green-GO chargers or wireless devices to charge the batteries

Optimal storage¶

When storing batteries for prolonged time when not used, it is advised to take the following guidelines into consideration. doing so will increase the batteries lifetime

• Store well ventilated and dry
• Store between 5 and 25 degrees Celsius
• Store with a approximate 40% S.O.C. arround ~ 3,7V

Cleaning batteries and battery compartments¶

although contamination, especially of the electrical contacts should be avoided, it is always possible that the contacts can become dirty and start to make less reliable contact.

Symptoms can be:

• An inserted battery does is not able to power up a Wireless device
• Pressing a battery harder into a Wireless device makes it able to power the device on
• An inserted battery does not start charging or never finishes charging

in these cases we strongly advice to Clean the complete inventory of NRGP and battery holders in wireless devices and chargers this, to prevent cross contamination from battery to charger/wireless device and vice versa.

Cleaning an NRGP¶

• Lightly dampen a swab with IPA
• Gently rub the swab over the batteries contacts until contamination dissolves and the contacts are visually clean
• Wait several minutes until the residual IPA is evaporated before operating the battery
• Regularly re-dampen the cleaning swab and replace if visually dirty

Cleaning an Battery slot¶

• Lightly dampen a swab with IPA
• Insert the swab horizontally into the battery slot.
• Gently rub the swab in an up-down motion over the contacts until contamination dissolves and the contacts are visually clean
• Wait several minutes until the residual IPA is evaporated before operating the battery slot
• Regularly re-dampen the cleaning swab and replace if visually dirty

What's in the box?¶

The Green-GO NRGP battery pack comes with the following package contents:

• 1 x Green-GO NRGP battery pack

Technical specifications¶

Type:Li-Ion

Capacity:1800 mAh

Nominal voltage:3,7 V

Charge current:500 mA

Dimensions (H/W/D):14 x 38 x 73 mm

Weight:45 g

Environment:Ambient storage temperature: 0° - 35° C

Downloads¶

Other¶

• MSDS & UN38.3 reports (ZIP archive)