Skip to content
Last update: December 7, 2023

The DNTI Dante Audio Interface

DNTI Front View

The DNTI Dante Interface is a quad port Dante stream device, used for integrating Dante streams in and out of the system, Featuring a full-color TFT or LCD display that shows information about channels, cue signals; configurable by a multifunction encoder, with access to many of the same functions and features as most other Green-GO devices.

Connectivity to Dante is achieved via a dual 10/100 Mbps “external network” port. Powered via PoE through the network cable connected to the devices Ethercon port or 12V DC connector (power supply not included).

Dante is an audio-over-IP platform used across audio industries for transport of AV signals around a network.

What's in the box?

The Green-GO DNTI Dante audio interface comes with the following package contents:

  • 1 x Green-GO DNTI Dante audio interface
  • 1 x Printed quickstart guide
Optional Green-GO accessories
  • Green-GO PoE network switches

Device overview

Front panel

DNTI Front Overview

Back panel

DNTI Back Overview

The user interface

DNTI UI Overview

The setup menu

Reset the memory cache

Tip: You will lose any device configuration by clearing the memory cache of your device.

While it is not necessary to reset a device's memory cache after updating a version 5 firmware, it may help to resolve issues after an update process has been completed. Resetting a device's memory cache is done in the forced Boot Mode:

  1. Power down your device.
  2. While powering up your device, press the Encoder
  3. You can release the button after the device booted into the forced Boot Mode.
  4. Press and hold the button identified in step two again for approximately 30 seconds.
  5. While resetting, devices with a display will show a countdown.
  6. Release the button after the countdown has run down.
  7. Restart your device.

Technical specifications


Dante connection




Written by: Chad Phelps, Henk-Jan Blok, Timo Toups